Featured
Change Kitchen Tap Washer Australia
Change Kitchen Tap Washer Australia. Carefully follow the instructions listed below: If it's only the hot tap that.

Hi @gingerred, welcome to workshop. Turn the mains tap off or use the isolation switch to. Step #3 turn on the water supply.
You Must Switch Off The Water At The Mains/Water Meter.
If there is a cap, pry it off gently with the tip of a stanley knife or screwdriver. Before changing the tap washer, ensure that the water supply to the tap is turned off. Once that’s been done, replace the old tap washer with a new one ensuring that there are no gaps between any parts.
Find The Small Tap Screws.
Use the pliers or screwdriver to remove the small nut or screw holding it. Make sure that you follow the. Following that you can slide off the handle.
With The Handle Off, Next Take Off The Tap Shroud.
Then, turn on the hot and cold taps at the sink you’re working. They will need to be removed carefully using a screwdriver. Make sure to turn the tap on and off, checking.
Turn Off The Hot And Cold Water Supply And Drain The Lines.
Once the valve stem is taken off, you’ll see the tap washer at the bottom. Changing a washer in a tap is a simple process which we have outlined below in 5 simple steps. The plug should be placed in the basin or bath after this to.
The Handles Lock Nut Must Be Removed So That The Handle Can Be Taken Off.
If this happens, then wait until everything calms down before trying again. You’ll need to find the mains stopcock (it’s usually under your. Once the tap has been turned off, the washer will be directed towards the seat, causing an increase in pressure.
Popular Posts
Explain How Private Land Use Can Change Over Time
- Get link
- X
- Other Apps
Comments
Post a Comment